• Show MOB: Switches automatically to the MOB page if a Man
Over Board event is triggered from another system on the
network. Refer to "Man Over Board (MOB)" on page 13
Files
File management system. Used to browse the contents of the unit's
internal memory and the content of a device plugged into the unit's
USB port.
Simulate
Runs the display with simulated data. Use the simulator to become
familiar with your unit before using it on the water.
When activated, the simulator mode is indicated on the display.
Restore defaults
Allows you to select which settings are to be restored to their
original factory settings.
Engine setup
Vessel setup
Set the number of engines, fuel tanks and total fuel capacity.
Engine display setup
A maximum of two engine’s data can be shown on each gauge.
The Engine display setup defines which engine’s data should be
displayed on a gauge if you have more than 2 engines.
Gauge limits
Sets the RPM and vessel fuel rate limits.
Ú
Note: These limits are a visual guide on the data pages. They do
not set any alarms.
Global reset
Resets the source selection on all displays connected to the
network.
64
Software setup | IS42 Operator Manual
To Next Page
Loading...
Need help?
General
