Singer S900 - Feed Dog Control

16
SPOOL PINS
+25,=217$/6322/3,1
Place thread spool on the pin and secure with a spool cap to
HQVXUHVPRRWKÀRZRIWKUHDG,IWKHWKUHDGVSRROKDVDWKUHDG
retaining slit, it should be placed to the right.
6HOHFWWKHFRUUHFWVSRROSLQFDSDFFRUGLQJ WRWKHW\SH DQG
diameter of spool being used. The diameter of the spool pin
cap should always be larger than that of the spool itself.
PRESSER FOOT LIFTER
There are three positions for your presser foot.
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to insert or remove
fabric, and to change presser foot.
3. Lift it to its highest position to accommodate thicker fabrics.
9(57,&$/6322/3,1
$WWDFKWKHVSRROSLQDQGSODFHDIHOWGLVFRYHULW3ODFHDVSRRO
of thread on the spool pin.
6SRROSLQFDS
&RXYUH¿O
Tapa del pasador carrete
6SRRO
Bobine
Carrete
6SRROSLQ
Porte-bobine
Pasador carrete
9HUWLFDOVSRROSLQ
Porte-bobine vertical
Pasador de carrete vertical
6SRRO
Bobine
Carrete
Thread retaining slot
)HQWHGHUHWHQXHGH¿O
5DQXUDGHUHWHQFLyQGHKLOR
6SRROSLQIHOWGLVFV
Rondelle feutre
'LVFRGHOSDVDGRUFDUUHWH
FEED DOG CONTROL
The feed dogs control the movement of the fabric that is
being sewn. They should be raised for all general sewing
purposes and lowered for darning, freehand embroidery and
monogramming so that you, not the feed dogs, are moving the
fabric.
Lower the feed dogs by removing the extension table and then
pushing the feed dog lever toward the machine.
To re-engage the feed dogs, push the lever back to the right.
Then, turn the hand wheel toward you one full revolution. You
will see the feed dogs raise back up.
'RZQ
Basse
$EDMR
Feed dog lever
/HYLHUGHFRQWU{OHGHVJULIIHV
Control de dientes