© Jan 2022 1-10 0607SE Maintenance Manual
SAFETY
BATTERY HAZARD
• Only connect the charger to a
grounded 3–wire AC outlet. Be
sure the charger is in proper
operating condition before
charging.
• Only use the charger provided
with the machine by the
manufacturer.
• Ensure the place where the
battery is charged is well
ventilated and far away from
sunlight, flame, spark or any other
hazards that may cause
explosion, and do not expose the
battery to the water or rain.
• Only the properly trained
personnel authorized by the
workplace are allowed to remove
the battery from the machine.
• Be sure to use the appropriate
number of personnel and proper
lifting methods when changing
the battery.
• During the assembling or
disassembling process, never use
the battery in a forciable manner,
and never allow the battery to fall
off.
• Never directly short-circuit the
battery outputs with electrical
cords.
• Should the battery acid spill out,
use bicarbonate (baking soda)
mixed with water to neutralize the
acid.
• Never store the battery in water or
humid atomosphere.
• Daily check the battery cable for
damage, and replace any
damaged parts before operating
the machine.
LITHIUM BATTERY HAZARD
• Only use the dedicated charger to
charge the battery.
• Do not allow lens, needles or
other sharp objects to contact
with the battery, otherwise the
battery membrane will easily get
damaged.
• Do not immerse the batttery into
the sea or water for an extended
period of time.
• Do not use the machine with the
battery close to a heat source (-
fire, heater, etc).
• Do not use the battery with the
positive or negative terminals
installed inversely.
• Do not directly connect the
battery to a power outlet .
• Do not throw the battery into a fire
or heater,
NOTICE
After charging the battery, be sure that:
• The battery cable connections are free of
corrosion.
• The battery hold-down and cable connections are
secured.
Adding terminal protection and anti-corrosion
sealants will help reduce corrosion of the battery
terminals and cables.