IM Machine Name Rev.: END 12
Qualified personnel with under-
standing of process-related systems
Electrical
Maintenance
Personnel
On electrical parts:
Fault finding
Service
Maintenance
Decommissioning
Dismantling
2.8 Safety Instructions for the Operating Personnel
Every person assigned to work on or with the welding laser system must have fully
read and understood this instruction manual.
● Start the welding laser system only with it in a technically faultless condition as
well as only for its intended purpose, safety and risk aware and in compliance
with this instruction manual.
No liability whatsoever shall be assumed for injury, damage and / or accidents that
arise from the non-observance of this instruction manual.
● Immediately rectify all faults.
● Always keep the instruction manual readily available at the welding laser system.
● Do not wear jewellery.
● Only reliable, trained and qualified personnel who have reached the statutory
minimum permissible age in accordance with the Young Persons Employment Act
may work on or with the welding laser system.
● Personnel to be trained, taught, instructed or who are undergoing general training
may only work whilst under the constant supervision of an experienced person.
If safety-related changes occur on the welding laser system:
● Immediately shutdown the welding laser system.
● Secure the welding laser system.
● Report the event to the responsible position / person.
To Next Page
Loading...
