IM Machine Name Rev.: END 38
6.2 Maintenance
General Maintenance Instructions
A high level of availability of the welding laser system is positively influenced through
compliance with the care and maintenance intervals.
● Regularly inspect welding laser system and inform the responsible person if
repairs or maintenance work are necessary.
Preparation of the Repair and Maintenance Work
● When working only use the correct tools and replace worn parts such as screws
or nuts only with original spare parts.
● Carefully identify components before their disassembly.
Injuries possible due to inadequate visibility
With poor visibility, potential sources of danger cannot be properly
recognized.
● Only carry out repair and maintenance work on the welding
laser system with adequate lighting.
Checking of the Safety Devices
● Check all safety equipment and devices in accordance with the
Maintenance Plan (Chapter 6.3) or the safety check list in the
Annexes.
● Document these checks in an inspection logbook.
If, due to the existing operating conditions or other requirements,
additional inspection positions or shorter inspection intervals need to be
observed, they must be additionally recorded in the safety check list by a
Safety Officer of the operating company.
If defects are detected during safety checks, the laser engraving machine must first
be put back into operation following appropriate maintenance and release by a
responsible officer of the operating company.
After the replacement and / or repair of electrical and / or electronic components, too, a
visual inspection must be carried out whereby the settings in accordance with the
relevant accompanying data sheets must also be checked.
To Next Page
Loading...