IM Machine Name Rev.: END 35
ā Keep readjusting as often as is necessary until the weld point and cross-hairs
coincide.
Illustration 17 Adjustment
You are now ready to start. Make use of the parameter list for your first welding tests
or book a laser welding course at Siro Lasertec.
5.5 Faults
Some of the operating faults listed here can be rectified with the help of the instruction
manual, for example, water shortage, cross-hair adjustment or defective laser lamp.
For the rectification of a possible fault, the housing must be opened only when the
welding laser system has been taken out of operation.
In the event of faults that cannot be rectified following the instructions in the Chapters
Service and / or Maintenance, contact the Technical Customer Service of Siro
Lasertec.
To Next Page
Loading...
