IM Machine Name Rev.: END 24
5 Operation
Every person involved with the operation, maintenance and repair of the welding laser
system must have thoroughly read and fully understood this Chapter “5 Operation”.
5.1 Safe Operation
Work on the welding laser system must only be carried out by trained or instructed
personnel. Danger to life and limb can occur in the event of improper and / or
incorrect use.
The welding laser system must only be operated by authorized, suitably skilled
personnel.
Due to his or her professional training, knowledge and professional experience as well
as knowledge of the accident prevention and health and safety regulations, a suitably
skilled person is able to assess and carry out the work assigned to him or her and
recognize potential hazards when he or she also satisfies the necessary personal
requirements for the work, for example, can work independently.
● Use the welding laser system only for the purpose that is normal or is specified by
the manufacturer.
● Always only operate the welding laser system in a technically perfect condition in
order to avoid accidents.
● Do not use third-party parts on the welding laser system as otherwise compliance
with the necessary safety is not guaranteed.
● Refrain from all working methods that impair the safety of the welding laser system
● Report immediately any changes (that impair safety) occurring on the welding
laser system to the responsible supervisor.
● Immediately shutdown welding laser system in the event of a fault impairing
safety. First put the welding laser system back into operation after the fault has
been rectified.
● Do not disassemble or manipulate any safety devices. Do not render safety
devices inoperative.
● Do not remove covers from drive sections before the dangerous movements have
come to a complete standstill. Correctly re-fit the covers before putting back into
operation.
To Next Page
Loading...
