13
Residual risks
Personal injury/ material damage
due to falling of raised parts
Keep unauthorized persons away. No people may
remain under suspended loads. Lift parts with
adequate lifting devices.
Personal injury/ material damage
due to tilting or falling of the product
because of non-observance of the
stated tightening torques
Observe the specified tightening torques. Fix the
product to components with adequate load-
bearing
capacities only. If no tightening torques are stated,
apply tightening torques according to the screw
size characteristics for 8.8 screws.
Personal injury/ damage to material
due to spilled or leaked lubricant
Be careful when connecting or disconnecting
lubricant feed lines. Always use suitable hydraulic
screw connections and lubrication lines for the
stated pressures. Do not mount lubrication lines to
moving parts or friction points. If this cannot be
avoided, use spring coils respectively protective
conduits.
Fire hazard or damage to the pump
due to an operation with defective
electrical components, e.g.
Connection cables and plugs.
Check the electrical components with regard to
damages before the first usage and then at regular
intervals. Do not mount cable to moving parts or
friction points. If this cannot be
coils respectively protective conduits.
Damage to the pump due to non-
observance of the admissible
relative duty cycle.
Operate the pump within the admissible relative
duty cycle only.
Damage to the pump due to an
installation at the place of use
without the mounting brackets and
washers provided for this purpose.
Mount pump only with the mounting brackets and
washers provided for this purpose.
Life phases: A = transport, B = installation, C = initial start-up, D = operation, E = cleaning, F = maintenance, G = fault, repair, H
= shutdown, K = disposal
To Next Page
Loading...
Need help?
General
