10
Persons authorized to use the product
Operator
A person who is qualified by training, knowledge and experience to carry out the functions and activities related to normal
operation. This includes avoiding possible hazards that may arise during operation.
Specialist in mechanics
Person with appropriate professional education, knowledge and experience to detect and avoid the hazards that may arise
during transport, installation, start-up, operation, maintenance, repair and disassembly.
Specialist in electrics
Person with appropriate professional education, knowledge and experience to detect and avoid the hazards that may arise from
electricity.
Foreseeable misuse
Any usage of the product other than as specified in this manual is strictly prohibited. Particularly prohibited are:
• Use of non-specified consumables, contaminated lubricants, or lubricants with air inclusions.
• Use of C3 versions in areas with aggressive, corrosive substances (e.g., high salt load).
• Use of plastic parts in areas with high exposure to ozone, UV light, or ionizing radiation.
• Use to supply, convey, or store hazardous substances and mixtures as defined in the CLP Regulation (EC 1272/2008) or
GHS with acute oral, dermal, or inhalation toxicity or substances and mixtures that are marked with hazard pictograms
GHS01-GHS06 and GHS08.
• Use to supply, convey, or store Group 1 fluids classified as hazards as defined in the Pressure Equipment Directive
(2014/68/EU) Article 13 (1) a).
• Use to supply, convey, or store gases, liquefied gases, dissolved gases, vapors, or fluids whose vapor pressure exceeds
normal atmospheric pressure (1013 mbar) by more than 0.5 bar at their maximum permissible operating temperature.
• Use in an explosion protection zone.
• Use without proper securing against excessively high pressures, in the case of pressurized products.
• Use outside of the technical data and limits specified in this manual.
Referenced documents
In addition to this manual, the following documents must be observed by the respective target group:
• Company instructions and approval rules
If applicable:
• Safety data sheet of the lubricant used
• Project planning documents
• Supplementary information regarding special designs of the pump. This you will find in the special system documentation.
• Instructions for other components for setting up the centralized lubrication system.
Prohibition of certain activities
• Replacement of or modifications to the pistons of the pump elements
• Repairs or modifications to the drive
Painting plastic components and seals
The painting of any plastic components and seals of the products described is prohibited. Completely mask or remove plastic
components before painting the main machine.
Safety markings on the product
Further to the findings of the workplace risk evaluation the operating company has to attach additional markings (e. g.
warnings, signs giving orders, prohibition signs or labelling as specified by CLP / GHS), where appropriate.
To Next Page
Loading...
Need help?
General
