12
Notes related to the UKCA marking
The UKCA conformity marking con-
firms the product’s conformity with
the applicable legal provisions of
Great Britain.
Note on EAC marking
The EAC conformity marking confirms the
product’s conformity with the applicable legal
provisions of the Eurasian customs union.
Note on China RoHS mark
The China RoHS marking confirms that there
is no danger to persons or the environment
from the regulated substances contained
within the intended period of use (number in
the circle) of the product.
Emergency shutdown
This is done by a course of action to be defined by the operator.
Assembly, maintenance, fault, repair
Prior to the start of this work, all relevant persons must be notified of it. At a minimum, the following safety measures must be
taken before any work is done:
• Unauthorized persons must be kept away
• Mark and secure the work area
• Cover adjacent live parts
• Dry any wet, slippery surfaces or cover them appropriately
• Cover hot or cold surfaces appropriately
Where applicable:
• Depressurize
• Isolate, lock and tag out
• Check to ensure live voltage is no longer present
• Ground and short-circuit
The product should be protected as much as possible from humidity, dust, and vibration, and should be installed so that it is
easily accessible. Ensure an adequate distance from sources of heat or cold. Any visual monitoring devices present, such as
pressure gauges, min./max. markings, or oil level gauges must be clearly visible. Observe the mounting position requirements.
Drill required holes only on non-critical, non-load-bearing parts of the operator's infrastructure. Use existing holes where
possible. Avoid chafe points. Immobilize any moving or detached parts during the work. Adhere to the specified torques.
If guards or safety devices need to be removed, they must be reinstalled immediately following conclusion of work and then
checked for proper function.
Check new parts for compliance with the intended use before using them.
Avoid mixing up or incorrectly assembling disassembled parts. Label parts. Clean any dirty parts.
First start-up, daily start-up
Ensure that:
• All safety devices are fully present and functional
• All connections are properly connected
• All parts are correctly installed
• All warning labels on the product are fully present, visible, and undamaged
• Illegible or missing warning labels are immediately replaced
To Next Page
Loading...
Need help?
General
