30
5.7.2 Phase codes for normal mode and alarm mode
In normal or alarm mode, the phase code corresponding to the program phase is shown on the display.
Phase code Description
Waiting for pressure discharge
(disCharge)
The interlocking switch is closed
Lubricant reservoir low level alarm
(Alarm, Grease)
Pressure low alarm (the line pressure does not rise high enough during the pressurisation time)
(Alarm, Low Pressure)
Pulse alarm (progressive system)
(Alarm Low amount of Pulses)
(the line pressure has not dropped low enough when the pressurisation phase starts)
An alarm from the SKF Doser monitor doser operation indicator.
The code is used only if SKF Doser monitors are in use.
An alarm from the air pressure switch of the grease spray system.
The code is used only if an air pressure switch is in use.
A warning of a pump change when a dual pumping centre (Dualset) is in use.
(Alarm, Pump Changed)
To Next Page
Loading...
Need help?
General
