36
Entering settings
1. Select the code for the setting to be changed on the display with ù.
2. Press SET.
3. The first number of the value to be set will be blinking on the display.
4. Select the desired number by pressing
ù.
5. Move to the next number by pressing
ø.
6. Save the setpoint by pressing SET.
7. Exit the setting mode by pressing
ø. The display will automatically return to normal mode after four minutes if no
buttons have been pressed.
Lubrication counter
The lubrication cycle counter can be reset when needed.
1. Select the code Cou for lubrication cycle counter by pressing
ù.
2. Reset the counter by pressing SET.
Lubrication cycle
The lubrication cycle setpoint is displayed as hours and minutes. A decimal point is used to separate hours and minutes.
The decimal point of the setpoint can be moved in the manner described below.
1. Select the code for the setting to be changed by pressing ù.
2. Press SET.
3. Set the desired value by pressing
ù and ø.
4. Press
ø.
5. The decimal point will start to blink.
6. Move the decimal point to the desired location by pressing ù.
7. Save the setpoint by pressing SET.
To Next Page
Loading...
Need help?
General
