EasyManuals Logo

Ski-Doo Scandic WT 550F User Manual

Ski-Doo Scandic WT 550F
123 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
CONTROLS, INSTRUMENTS AND EQUIPMENT
8) Ignition Switch/Start
Button
Ignition Switch
550F Model
1 1
2
2
3
A23H04A
MANUAL START/ELECTRIC START
1. OFF
2. ON
3. START
Manual Starting
To start the engine, first turn the key to
ON position, then pull rewind starter
handle. To stop the engine, turn the
key to OFF position. See illustration
above.
Electric Starting
To start engine, turn key to START po-
sition and hold until engine has started.
See illustration above.
NOTICE
Do not engage electric
starter for more than 10 seconds
at a time. A rest period of 30 sec-
onds should be observed between
the cranking cycles to allow electric
starter to cool down. Using elec-
tric starter when engine has started
could damage electric starter mech-
anism.
Release the key as soon as the engine
starts. Key returns to ON position as
soon as it is released.
If the engine does not start on the first
try, turn the key back to OFF and wait a
few seconds before restarting. Tostop
engine, turn the key to OFF.
NOTE: Engine may be manually
started with rewind starter if nece
s-
sary.
If starter does not operate, check start-
ing system fuse condition. Refer to
STARTING SYSTEM AND ELECTRIC
POWER OUTLET FUSE
.
Start Button
V800 Model
To start engine, push START button
and hold until engine has started.
NOTICE
Do not hold START but-
ton more than 10 seconds at a time.
A rest period of 30 seconds should
be observed between the cranking
cycles to allow starter to cool down.
Holding START button when engine
has started could damage starter
mechanism.
Release START button immediately
when engine has started.
If engine does not start on first try, wait
a few seconds then repeat procedure.
V800 Model
NOTE: If engine does not start after
the second try, wait until all lights are
shutdown then repeat procedure.
All Models
To stop engine, turn off emergency en-
gine stop switch or pull off tether cord.
If starter does not operate, check start-
ing system fuse condition. Refer to
STARTING SYSTEM AND ELECTRIC
POWER OUTLET FUSE
.
550F Model
NOTE: Engine may be manually
started with rewind starter if neces-
sary.
9) Engine Cutout Switch
General
The engine cutout switch (tether cord)
is located to on the LH side of console.
32
______________

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ski-Doo Scandic WT 550F and is the answer not in the manual?

Ski-Doo Scandic WT 550F Specifications

General IconGeneral
BrandSki-Doo
ModelScandic WT 550F
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals