MAINTENANCE PROCEDURES
6. Reposition snowmobile on ground.
7. Install rear wheel caps if so
equipped.
Front Suspension
Front Suspension Lubrication
Lubricate at grease fittings using SUS-
PENSION GREASE (P/N 293 550 033).
Rear Suspension
Rear Suspension Condition
Visually inspect all suspension compo-
nents including slider shoes, springs,
wheels, etc.
NOTE: During normal driving, snow
will act as a lubricant and coolant for
the slider shoes. Extensive riding on
ice or sanded snow, will create exces-
sive heat build-up and cause prema-
ture slider shoe wear.
Stopper Strap
Inspect stopper strap for wear and
cracks, bolt and nut for tightness. If
loose inspect holes for deformation.
Replace as required. Torque nut to
9N•m±1N•m(80lbf•in ±9lbf•in).
Rear Suspension Lubrication
Lubricate at grease fittings using SUS-
PENSION GREASE (P/N 293 550 033).
Skis
Ski Inspection
Check the condition of the skis, ski run-
ners and ski runner carbides. If worn,
contact an authorized Ski-Doo dealer.
WARNING
Excessively worn skis and/or ski
runnerswilladverselyaffectsnow-
mobile control.
Steering
Steering Inspection
Visually inspect steering for tightness
of components (steering arms, tie
rods, ski bolts, ski legs, etc.). If nec-
essary, contact an authorized Ski-Doo
dealer.
Headlights
Headlights Bulb Replacement
NOTICE
Never touch glass portion
of an halogen bulb with bare fingers,
it shortens its operating life. If glass
is touched, clean it with isopropyl al-
cohol which will not leave a film on
the bulb.
To replace a burnt headlights bulb, re-
move the following:
– Windshield assembly
– Air intake dashboard cover.
A29H1IA
Taillight
Taillight Bulb Replacement
If taillight bulb is burnt, expose the bulb
by removing the red plastic lens. To re-
move, unscrew the 2 lens screws.
78
______________
To Next Page
Loading...
Need help?
General
