BlueControl Insect
Technical User Guide 43
It is possible to save and load a backup of the current settings
and report page.
It can be done either on the controller's internal CPU module,
SD card, or USB stick.
If settings are to be copied to other controllers, use an SD card
or a USB stick.
11.3.1 Backup of historical data
This CPU module will automatically save all historical data to the internal memory and only use the SD card as
backup media.
IMX based CPU module (two LAN ports)
Backup of historical data can be set to take place automatically once a day, which means that a new backup will
always be available if the CPU needs to be replaced. The backup is saved to an SD card in the CPU module.
If no previous backup has been made or if a new backup is required, this can be done manually at any time.
1. Select Save FarmOnline data i the menu Technical
| Service | Backup | SD card.
2. Wait until the controller indicates that the backup has been
saved.
11.3.2 SD card and USB stick
Using an SD card or a USB stick, it is possible to backup the controller setup and data including settings, pages,
historical data, house name, IP address, calibration values, etc.
To prevent data loss when replacing a defective controller or individual hardware parts, it is possible to restore
all types of data from the SD card.
The USB stick can also be used to copy data from one controller to another and to store data on a PC.
To Next Page
Loading...
Need help?
General
