17
SJ12 E, SJ16 E, SJ20 E
243762ABA
Safety instructions Section 2 – General Safety Precautions
DO NOT drive elevated near
depressions or holes of any
type, loading docks, debris,
drop-offs or surfaces that may
affect the stability of the MEWP.
IF OPERATION IN AREAS
WITH HOLES OR DROP-OFFS
IS ABSOLUTELY NECESSARY,
elevated driving is not allowed.
Position the MEWP horizontally
only with the platform fully low-
ered. After making sure that all
four wheels have contact with a
rm, level surface, the platform
can be raised. After elevation,
the drive function must not be
activated.
DO NOT ascend or descend grades greater than
the maximum inclines listed in Section 7.3. Only
ascend or descend slope when the platform is
fully lowered.
DO NOT operate a MEWP that
has ladders, scaffolding, or
other devices on it to increase
the platform size or work height.
DO NOT exceed the maximum
side force shown on the
capacity label when the platform
is elevated (refer to Section 7.4).
DO NOT use the MEWP as a
crane.
DO NOT sit, stand, or climb on
the guardrails.
DO NOT climb on the base or
the mast.
DO NOT collide or crush.
Be aware of obstructions,
personnel, or other possible
hazards around the MEWP
when elevating, lowering, or
driving. Keep all body parts
inside the platform when
elevating or driving. Be aware
of blind spots when operating
the MEWP.
DO NOT elevate the platform
when the MEWP is on a truck,
forklift, or other device or
vehicle.
DO NOT use the MEWP
when the wheels or tires are
damaged. Make sure the wheel
nuts and cotter pins are in place
(refer to Section 4.2-6).
To Next Page
Loading...
