Skyjack SJ12 E - Base; Wheel;Tire Assembly

35
SJ12 E, SJ16 E, SJ20 E
243762ABA
Visual and daily maintenance inspections Section 4 – Inspections Before Operation
4.2-5 Base
Do the inspection that follows:
1
Base weldment
▪
There are no cracks in the welds or the
structure.
▪
There are no signs of deformation
2
Display Panel
▪
Make sure the panel is correctly attached and
there is no damage.
3
Battery charger
▪
Make sure the battery charger is correctly
installed, and in good condition.
▪
Make sure there is no visible damage.
4
Pothole protection
▪
Make sure there are no visible cracks or signs
of damage or deformation.
5
Steer cylinder
▪
Make sure the steer cylinder is correctly
installed.
▪
Make sure there are no loose or missing
fasteners.
▪
Make sure there is no visible damage.
4.2-6 Wheel/tire assembly
Do the inspection that follows:
6
Wheel/tire assembly
▪
Do a check on all the tire treads and sidewalls
for cuts, cracks, and unusual wear.
▪
Do a check on each wheel for damage and
cracked welds.
▪
Make sure the wheels are correctly aligned
vertically and horizontally.
▪
Make sure there is no visible damage.
WARNING
Do not use tires other than the tires that Skyjack
species for this MEWP. Do not mix different types
of tires or use tires that are not in good condition.
Only replace the tires with the same types that are
approved by Skyjack. The use of other tires can
make the MEWP less stable. If you do not obey,
there is a risk of death or serious injury.
7
Wheel nuts
▪
Make sure the castle nut is in position and is
tight.
▪
Make sure the cotter pin is correctly installed.
6
7
1
4
3
2
5