SLAYER STEAM LP USER MANUAL V1.1 | JUNE 2019 14
STEP 4: CONNECT POWER
Your Slayer Steam machine will ship with the power configuration
requested at the time of purchase. In most cases, this will include a plug
end on the power cord. If your machine does not include a plug, do not
attempt to wire it yourself. Only an electrician or approved technician
should wire the power cord into an appropriately-rated plug end.
INCLUDED PARTS
• External rotary pump and motor
PROCEDURE
1. Ensure main power rocker switch is in the o O position (see page 15)
2. Locate the quick connect plug on the smaller gauge wire. Insert into
the pigtail on the pump motor
3. Ensure both steam actuators are in the o position and the drain
hoses and water lines are connected (per previous steps)
4. Insert the mains power plug into the appropriately rated and grounded
receptacle
Do not move the steam actuators to the “on” position. Do not turn
on the main water supply.
NOTE: UL machines ship capped with a plug end, CE machines DO NOT.
Purge
O
On
To Next Page
