SLAYER STEAM LP USER MANUAL V1.1 | JUNE 2019 16
STEP 6: TURN ON ELEMENTS
PROCEDURE
1. Ensure that all brew actuator paddles are “OFF” (to the right), the cup
tray panels have been removed, and the tanks have filled completely
(per previous steps)
2. Turn on the heating elements by moving the heating element
BREAKER to the left, the “on” position.
Do not move the steam actuators to the “on” position as the
machine will automatically cycle the valves during initial heat up.
3. Wait until the machine has heated fully and the pressure reads 1+
bars on the Barista Dashboard, then move one of the steam actuators
down, to the “On” position. If steam is produced, proceed to the next
step. If no steam is produced, turn the main power On and O; wait
several minutes before repeating this step.
4. Check the inside of the machine for leaks or collected water.
The anti-suction valve on the steam tank may sputter and
release small drops of water when first building pressure. During
your inspection, check for large pools or steady streams of
water.
5. Install the cup tray.
6.
PLEASE NOTE: The Steam LP is designed to operate
To Next Page
Loading...
