SMART Board SB480iv2 - Page 32

CHAPTER 3
USING YOUR INTERACTIVE WHITEBOARD SYSTEM
22 smarttech.com/kb/170782
Setting Use Notes
Information Provides the Model Name,
Source, Resolution, Software
Version, Color Space and
Aspect Ratio
Lamp Settings sub-menu
Lamp Hours
Used (Normal)
Displays the number of lamp
hours while in Normal mode.
Lamp Hours
Used (ECO)
Displays the number of lamp
hours while in Eco mode.
Lamp Life
Reminder
Turns on or turns off the lamp
replacement reminder.
This reminder appears 100 hours before the
recommended lamp replacement.
Lamp Power
Mode
Sets the lamp power mode
(Normal, Auto, ECO1 or ECO2).
The default is Normal.
Normal displays a high-quality, bright image.
ECO1 and ECO2 increases the lamp life by
decreasing the brightness of the image.
Auto enables ImageCare mode which
improves lamp life under most
circumstances.
Clear Lamp
Hours
Resets the lamp hours. Always reset the lamp hours after you
replace a lamp, because lamp service
reminders are based on the current hours of
use. See Resetting the lamp hours on
page29 for details on the lamp hours reset
procedure.
Filters Remind (Hour) sub-menu
Filters Remind
(Hour)
Sets a reminder to clean the
filter (0 to 1000 hours).
The default is 0 hours.
Cleaning Up
Reminder
Turns on or turns off the filter
reminder.
The default is off.
LANMenu
DHCP Displays the status of the
network’s Dynamic Host
Configuration Protocol (DHCP)
as On or Off.
The default is on.
On enables a DHCP server on the network to
automatically assign an IP address to the
projector.
Off enables an administrator to assign an IP
address manually.