SMART Board SB480iv2 - Page 33

CHAPTER 3
USING YOUR INTERACTIVE WHITEBOARD SYSTEM
23 smarttech.com/kb/170782
Setting Use Notes
IP Address Displays the projector’s current
IP address in values between
0.0.0.0 and 255.255.255.255.
To assign the projector’s IP address, use the
projector’s web page to enter an address or
use a DHCP server to assign a dynamic IP
address (see Remotely managing your
system through a network interface on
page45).
Subnet Mask Displays the projector’s subnet
mask number in values
between 0.0.0.0 and
255.255.255.255.
Gateway Displays the projector’s default
network gateway in values
between 0.0.0.0 and
255.255.255.255.
DNS Displays the projector’s
primary domain name server
(DNS) IP address in values
between 0.0.0.0 and
255.255.255.255.
Store
Stores the values you entered.
Reset Resets values in the LAN menu
to their default values.
If you select Yes, all LAN settings reset to
their defaults, reversing any menu changes
you made. This action is irreversible.
Don’t adjust this setting unless you want to
reset all of the applied settings, or unless
you’re advised to by a SMARTSupport
specialist.