Snap-On EEWB330A - Maintenance; Storage; Changing the Main Fuse

Snap‐onEEWB330AHandspinWheelBalancer
6.0Maintenance
Thisunitisdesignedtooperateforalongtime.Ifthe
operatorshutsdowncorrectly(5.4.4)attheendof
eachshift,nofurthermaintenanceisrequired.Thisunit
mustnotbeopenedbytheoperator,exceptin
accordancewithexplicitinstructions.

6.1Storage
Whentheunitwillbestoredforaseveralweeksor
longer,preparetheunitcorrectly:Shutdowntheunit
properly(5.4.4).Removethestubshaftfromtheflange.
Applyalight,non‐corrosiveoilontoallthreadsand
cones.Wrapoileditemsinpapertokeepthepartsdust
free.Whentheunitwillbeputintouseagain,cleanall
oiledparts.


6.2Changingthemainfuse 

RefertoFigure6‐1.Switchofftheunit.Unplugthe
powercordfromthepoweroutlet.Removethepower
cordfromthemainscableinlet.Pulloutthefuseholder
(1).Replacethefusebyanidenticalratedone.Bringunit
backtoitsoriginalstate.