Snap-On EEWB330A - Troubleshooting; Problem Diagnosis

Snap‐onEEWB330AHandspinWheelBalancer

7.0Troubleshooting

Ifaproblemariseswiththewheelbalancer,proceedin
thefollowingordertosolvetheproblem:

1.Rethinkthelaststepstaken.Didyouworkaccording
tothemanual?Didtheunitworkasdescribedand
expected?

2.Checktheunitaccordingtothepointslistedinthis
chapter.

3.CallyourTech Support at 800-225-5876.
Thesetupofthischapteris:

Problem1.
Possiblecause
#1Possiblesolution(s)
2.Possiblecause
#2Possiblesolution(s)

Whenswitchedon,nothinglightsup.
1.PowerswitchinOFFposition.

Whenswitchedon,nothinglightsup.
1.PowerswitchinOFFposition.SetpowerswitchinON
position.
2.Nopowercableconnected.Connectpowercableto
poweroutlet.
3.Nomainspower.Checkpowersupply,powersystem
fuses.
4.Unitfuse(s)blown.Replaceunitfuse(s)(6.2).Ifthe
fuse(s)has(have)recentlybeenreplaced,callserviceto
checktheunit.

Whenswitchedon,abeepisheardfor1second.
1. Configurationerror.
2. CallTech Support

Displayappearstofreezeorlockup.
1. Theunitmaybeinaprogram,waitingfora
specificaction.
2. Finishtheprogramcurrentlyinuse.Switchoff
theunit.Waitfor20seconds,switchontheunit.
3. Proceed.2.Powertothebalancermayhave
beeninterrupted.Switchofftheunit.Waitfor
20seconds,switchontheunit.

4. Proceed. Ifthishappensfrequently,haveyour
powersystemchecked.Ifthatisokay,call
technicalserviceteam.