Snap-On EEWB330A - Error Codes (E-Codes); E-Code Descriptions and Solutions

Snap‐onEEWB330AHandspinWheelBalancer
7.1.2E‐codes

WhentheE‐codeisdisplayed,alowbeepisgenerated.
Wheneveracodeappears:Noteitdownlookupthe
codeinthelist.Ifthecodeisnotdescribed,callservice.
Performthestepsdescribed.Thesetupofthischapter
is:
CodeDescription:Step(s)tobeperformed.Someerror
messagesaredisplayedforapprox.3secondsonthe
displayoftherightside.Tocleartheerrorcode
immediatelypresstheSTOP key.

E9(7.1.3)

E10
Gaugearmremovedfromidlepositionduringwheel
spin.Bringgaugearmtotheidleposition(fullyinand
down).Re‐spinthewheelwithouttouchingthegauge
arm.Iftheerrorappearsagain,havethegaugearm
calibrated(bytheservicedepartment).Displayclears
afterseveralseconds.

E11
Duringignitionthegaugearmisnotintheidleposition.
Movethegaugearmbackcarefullytotheidleposition.
Theerrorshoulddisappearwithinafewseconds.Ifthe
errorappearsagain,contacttheservicedepartment.

Note:BypressingSTOPyoucancontinuetousethe
machinebutallthewheeldatamustbeinserted
manually(5.6.3).

E14(7.1.3)

E21(7.1.3)