Snap-On EEWB330A - Error Code Reference; Additional E-Code Explanations

Snap‐onEEWB330AHandspinWheelBalancer
E22
Speedlow
Therotationspeedofthewheelhasnotreachedthe
minimumlimitneededtoenablebalancing.Checkthat
thebrake(pedal)orwheelisnotaccidentallyblocked.
Checkthatsomethingisnotbrakingorobstructingthe
wheel.Checkthepowersupply.Fitthewheelcorrectly.
Contacttheservicedepartment.

E23(7.1.3)

E24
Velocityfluctuations
Ifthespeedofthewheeltokeeptorequiredspeedthe
needstobefixed.
•Checkthatthewheelisnotobstructedorimpededby
something.
•Checkthepowersupply.
•Fitthewheelproperly.
•Callforservice.

E25
Reverseerror.
Theshaftisrotatingatacertainspeedbutinthewrong
direction.Applythebrake.
Contacttheservicedepartment.
Thedisplayclearswhenrotationstops.

E26
Noacceleration.
Noshaftaccelerationhasbeenregistered.
Contacttheservicedepartment.

E27
Slippingregistered.
Thewheelslipsontheshaft.
Fitthewheelcorrectly.

E28
Speedlimitreached.
Contacttheservicedepartment.

E50
Manufacturer’scalibrationincomplete
Contacttheservicedepartment.

