Snap-On EEWB330A - Error Code Resolution; Calibration and Startup Errors

Snap‐onEEWB330AHandspinWheelBalancer
E51
Calibrationfailed.Switchunitoff,waitfor20seconds.
Switchuniton.
Retrycalibration,or:
Contacttheservicedepartment.

E52
Thecalibrationweightisontheoppositesidetothe
calibrationcarriedoutbythemanufacturer.
FittheUserCalibrationWeightcorrectlyontheleftside
oftheflange.
RepeatCalibration.
Contacttheservicedepartment.

E82
Faultduringself‐testatstart‐up.
Switchunitoff,waitfor20seconds.
Switchuniton.

E92
Duringthesecondattemptthegaugearmfordistance
andrimdiameterwasstillnotinthehomeposition.The
gaugearmisrenderedinoperative.Wait5seconds,or
presstheSTOPkeytocontinue.
