Set, View Terms of Use
Control page
Load Filament & Unload Filament
Load Filament
Refer to Load Filament.
Unload Filament
Refer to Unload Filament.
Moving the extruder and the heated bed
Click Control > Move, and then click the button in the corresponding direction to
control the movement of the left and right extruders and the heated bed in the X, Y, and
Z directions.
To move the extruder and heated bed to their home positions, click the Home button in
the upper right corner of the interface. The left extruder will move to the left front
corner, the right extruder will move to the right front corner, and the heated bed will
move down to the lowest point.
Set the heated bed temperature
Click Control > heated bed, then slide to the target heated bed temperature.
Turn on and off the motor
Click Control > Motor and then click to toggle it on and off. When the motor is turned
off, you can move the extruder by hand for manual loading and manual Unloadion (see
Loading and Replacing filaments).
When the motor is off, click Home Button before
entering the Control > Move page.
using the
screen to control extruder movement.
To Next Page
Loading...
