Snapmaker J1 - Page 36

Density 1.16g/cm ³ at 23 ˚ C
Melt index 9.3g/10 min
Tensile strength
23.11 ± 0.63MPa
100% modulus
13.24 ± 0.29MPa
Elongation at break
462.3 ± 21.1%
Shore hardness
95A
Recommended printing parameters
Storage Ambient Temperature &
Humidity
Room temperature, relative humidity < 25%
Drying temperature & duration 70
˚
C，8h
Operating ambient temperature &
humidity
Room temperature, relative humidity < 25%
Print temperature
200˚C–220˚C
heated bed temperature
25
˚
C–50
˚
C
Retraction distance
0-2mm
36