Snapmaker J1 - PVA Filament Details

TPU absorbs moisture from the air very easily. Store it in a dry place.
Retraction speed
20-50mm/s
Print speed
40mm/s–100mm/s
Fan Open
Standby temperature
120
˚
C
filaments are recommended Easily stripped PLA, TPU, PVA
PVA
filament characteristics
Diameter
1.75mm
Density 1.37 G/cm ³ at 21.5 ˚ C
Melt index 7.8g/10 min
Recommended printing parameters
37