Snapmaker J1 - Page 92

If it is difficult to remove the solid glue, you can click Control >
heated bed on the touchscreen, heat the heated bed to 50℃ and then try
to scrape it off. It is recommended to wear insulated gloves to avoid
hot hands.
If it is difficult to remove the residue, you can click Control >
heated bed on the touchscreen, heat the heated bed to 50℃ and then try
to scrape it. It is recommended to wear insulated gloves to avoid hot
hands.
Remove the solid glue
Maintenance scenario
Before printing, apply a proper amount of solid glue on the glass platform to improve the
adhesion effect of the first layer. However, after printing, if the residual solid glue on
the surface of the platform is not cleaned in time, the effect of the next printing may be
affected.
Maintenance frequency
At least once a month, or after each time you apply solid glue to the glass platform.
Maintenance method
1. Prepare cleaning tools: wiping cloth (provided, see tool box) and clean water.
2. Turn off the printer and turn off the power.
3. Wipe the residual solid glue on the glass platform with a wiping cloth dipped in a proper
amount of water until there is no visible residue on the surface of the platform.
Remove grease and dust
Maintenance scenario
When the skin of human hands or other parts touches the glass platform, a small amount of
natural oil may be left on its surface. Some dust in the air will also adhere to the glass
platform. Over time, the adhesion of the first layer of the glass platform may be affected.
Maintenance frequency
At least once a month, or when you find that the first layer of adhesion is not good.
92