Snapmaker J1 - Page 94

Before removing the glass platform, please make sure that
the glass platform has been cooled to room temperature to
prevent hot hands.
If it is difficult to remove it with clean water, you can use a wiping
cloth dipped in a proper amount of alcohol to try to remove it again.
After cleaning, wash the glass platform again with clean water.
1. Prepare the cleaning tool: wiping cloth (provided, see tool box).
2. Lift the glass platform out of the printer.
3. Wash the glass platform with clean water and clean the surface of the glass platform with
wiping cloth until the surface of the platform is free of visible grease, dust or other
impurities. When finished, rinse the glass platform again with clean water.
4. Install the glass platform to the printer.
5. On the touchscreen, click Control > heated bed, slide to set the heating temperature to
60℃, and click Heat to dry the glass platform.
Clean the heated bed
Maintenance scenario
When calibrating, the machine will automatically calculate the offset when printing according
to the thickness of the glass platform after obtaining the data of the heated bed leveling
point. Foreign matter such as filament debris on the heated bed may cause the calibration to
fail.
Maintenance frequency
At least once a month.
Maintenance method
1. Prepare the cleaning tool: wiping cloth (provided, see tool box).
2. Turn off the printer and turn off the power.
3. Remove the glass platform and place it in a safe place.
4. Gently wipe the heated bed with a cloth until there is no visible foreign material on the
heated bed.
94