Sodi Sigma DD2 - Maintenance; 6.1 - Brakes

This document can not be reproduced or released without the Sodikart authorization.
MAN.SIG.EN.02
04/2014
26
CONFIGURE THE KART ACCORDING TO THE GUIDE INSTRUCTIONS
User maintenance guide
6 - Maintenance
6.1 - Brakes
6.1.1 - Fluids and lubricants
Do not use any oil-based lubricant, which would cause
swelling of the rubber parts.
SODIKART recommends the use of DOT 4 brake uid
(refer to the ITAKA website for product references) and
recommends that the disc and pads should be cleaned
using brake cleaner only (refer to the ITAKA website for
product references).
Use PFG110 grease to install the seals (visit the ITAKA
site for product catalogue numbers).
6.1.2 - Frequency of cleaning and maintenance
Before
any
session
After 1
meeting or
100 km
After 3
meeting or
300 km
After 5
meeting or
500 km
As
soon as
required
Checking the brake uid level X
Replacing the brake uid X
Checking the brake pads for wear X
Replacing the brake pads X
Checking for leaks in the hose X
Checking the condition of the brake hose X
Checking the tightness of the kart brake system X
Checking the condition of the brake disc X
Checking the brake disc for wear X
Replacing the brake disc X
Brake uid.....................SUPER BLUE DOT4
Ref : LU842.010
► The Super Blue brake uid has been
designed for racing use and is used
exclusively for this purpose (forbidden
on open road).
Brake cleaner
............................... WYNN'S
Ref : LU835.001
Grease ..........................Grease PFG110
Ref : LU823.004
► Use brake uid DOT4 only. Using
another brake uid could cause leaks
and failure of the brake system.
●● The●brake●system●is●not●compatible●with●
DOT●5.
●● Place●the●uids●in●watertight●cans●and●
recycle●them●according●to●the●regulations●
in●force.