Sodi Sigma DD2 - 5.2.1 - Adjustment of front tracking width; 5.2.2 - Adjustment of front wheel height

This document can not be reproduced or released without the Sodikart authorization.
MAN.SIG.EN.02
04/2014
20
CONFIGURE THE KART ACCORDING TO THE GUIDE INSTRUCTIONS
User maintenance guide
5.2 - Adjustment of front wheels
5.2.1 - Adjustment of front tracking width
The adjustment of the front width is realized with
several spacers (1 spacer of 15mm, and 3 spacers of
5mm for each stub axle), and 2 hubs type (short hub:
80mm or long hub: 100mm).
● The wider the front is widened, the harder
the steering is hard.
● The narrower the front is narrows, the
easier the steering is easy.
● If you wish increase the grip of front, it
sufce to increase the width of the front
with spacers.
Dry track
D
It is advisable to adjust the front with a spacer of 5mm
(1 spacer of 5mm inside), and use the long hubs:
100mm.
●● With●the●front●brake●on●your●chassis,●the●
adjustment●of●the●front●is●limited.●
●● No●more●than●20mm●of●spacers●(1●spacer●
of●15mm●and●1●spacer●of●5mm),●yoke●side●
on●each●stub●axle●if●the●kart●is●equipped●
with●front●brake.
Wet track (without front brake)
D
We advise you to adjust the front to the maximum (1
spacer of 15 mm and 3 spacers of 5mm inside), and
use the long hubs: 100mm.
Wet track (with front brake)
B
A
It is advisable to adjust the front with a spacer of 20mm
maximum (1 spacer of 15mm and 1 spacer of 5mm
inside), and use the long hubs: 100mm.
●● With●the●front●brake●on●your●chassis,●the●
adjustment●of●the●front●is●limited.●
●● No●more●than●20mm●of●spacers●(1●spacer●
of●15mm●and●1●spacer●of●5mm),●yoke●side●
on●each●stub●axle●if●the●kart●is●equipped●
with●front●brake.
●● Use●longs●hubs:●100mm●on●wet●track.
5.2.2 - Adjustment of front wheel height
4mm
4mm + 2mm
● Place one 4mm spacer on top and one 4 mm + one
2 mm spacer at the bottom.