Sodi Sigma DD2 - Replacing the Front Master Cylinder Pistons; Cleaning; If WD-40 or a Similar Cleaning Product Is Splashed; Accident

This document can not be reproduced or released without the Sodikart authorization.
MAN.SIG.EN.02
04/2014
37
USE SPARE PARTS OF SODI ORIGIN
User maintenance guide
6.1.13 - Replacing the front master cylinder
pistons
This operation must be performed by a
Sodikart dealer.
5
2
1
3
4
Legend
1 Screw
2 Nut
3 Handle
4 Push rod
5 Piston
Removing
● Remove the screw (1) and the nut (2).
● Remove the handle (3) and the push rod (4).
● Remove the piston (5) from the master cylinder.
● Clean the body of the master cylinder. Do not use
WD40 or other greasy products to clean the master
cylinder.
► Do not use any cleaning product that
could damage the seals. A brake uid
leak could appear, causing a serious or
fatal accident.
Reassembly
● Apply PFG110 grease to the piston (5).
● Reinsert the piston (5) in the master cylinder.
● Reinstall the handle (3) and push rod (4) using the
screw (1) and nut (2).
●● Replace●any●defective●parts,●using●only●
original●SODIKART●parts.
6.1.14 - Cleaning
Brakes should be cleaned using a dry cloth and brake
cleaner only.
Do not use WD40 or other greasy products to clean the
callipers and brake discs.
► If WD-40 or a similar cleaning product is
splashed on the brake disc or calliper,
braking will be less efcient or possibly
totally ineffective for a few revolutions.
This could cause a serious or fatal
accident.
► Do not apply WD-40 or other cleaning
products to the brake pump.