Sojet V1H - Terms and Definitions

65
Appendix 1: Terms and Definition
SN
Term
Description
Remark
1
Print delay
To adjust the distance from the time
when photocell detected the object till
printing.
If set delay distance as 30mm,
then it will start to print after
30mm later when photocell
detect the object
2
Initial value
Initial value from printing
For example, if set initial
value as 9, the first print value
is 9
3
Time change
Users can set day switch time
When set day switch as
“08:00” July 10, then the
time is 07:59 July 09 for all
printing before /on“07:59”
4
Pre-purge
To avoid printhead clogged
To avoid printhead clogged
5
Printhead
cleaning
To clean printhead
To clean printhead
6
Nozzle switch
Switch nozzle to get better print result.
Switch nozzle to get better
print result.
7
Continuous
printing
Multi-printing during the time from
photocell begins and ends
8
Screen saver
time
To shut down screen to save electricity
power.
For example, if set screen
saver time as 0.5H, if no more
operation within 0.5H, the
screen will be shut down.