23
Installation and Wiring
NOTICE!
• Observe the bubble of spirit level and adjust the wall bracket until the bubble stays in
the middle.
b. Drill holes with Ø8 drill, make sure the holes are deep enough for the installation
(Depth: at least 45 mm).
Depth:
>45 mm
Ø
8 drill
Figure 6-8 Drill the holes
c. Insert the expansion tubes in the holes.
Expansion tube
Figure 6-9 Insert the expansion tubes
d. Align the bracket and the cable hook (only for Plug Type) with the holes, and
screw the self-tapping screws with the cross screwdriver.
M4
1.5-2 N·m
Figure 6-10 Secure the bracket and the cable hook
To Next Page
Loading...
