Solcon RVS-DX Series User Manual

22 • Control Keypad
________________________________________________________________________________________
7.5.3 Obtain Default Parameters
Press the Mode and ▼ keys simultaneously.
The LCD will display:
TEST/MAINTENANCE
***OPTIONS***
Press the Select key three times.
The LCD will display:
STORE ENABLE
DEFAULT PARAMET.
Press the Store + Mode keys simultaneously.
The LCD will display:
DATA SAVED OK
And after a few seconds the LCD will display:
% OF MOTOR FLA
I<0.1 FLC
CAUTION!
Obtaining DEFAULT PARAMETERS erases all previously modified settings
and requires the operator to reprogram all parameters that differ from the
factory default.
Note: It is especially important to reprogram the FLC (as shown on the label of
the RVS-DX), FLA and RATED LINE VOLT. value again.
7.5.4 Reset Statistical Data
Press the Mode and ▼ keys simultaneously.
The LCD will display:
TEST/MAINTENANCE
***OPTIONS***
Press the Select key four times.
The LCD will display:
RESET STATISTICS
Press the Reset + Store keys simultaneously.
The LCD will display:
DATA SAVED OK
And after a few seconds the LCD will display:
STATISTICAL DATA
- **** -
Press the Mode and go back to:
% OF MOTOR FLA
I<0.1 FLC

Solcon RVS-DX Series Specifications

General

Brand	Solcon
Model	RVS-DX Series
Category	Controller
Language	English