2 • Table of content
__________________________________________________________________________________
RVS-DX Instruction Manual
1. TABLE OF CONTENT
1. Table of content ........................................................................................................................ 2
2. Safety & Warnings .................................................................................................................... 4
2.1 Safety .......................................................................................................................................... 4
2.2 Attention ...................................................................................................................................... 4
2.3 Warnings ..................................................................................................................................... 4
3. Technical Data .......................................................................................................................... 5
3.1 Introduction ................................................................................................................................. 5
3.2 Rating and frames sizes ............................................................................................................. 5
3.3 Starter Selection ......................................................................................................................... 5
3.3.1 Motor current & Starting Conditions ................................................................................ 5
3.3.2 Mains Voltage (line to line) .............................................................................................. 6
3.3.3 Control Voltage ............................................................................................................... 6
3.3.4 Other Options .................................................................................................................. 6
3.3.5 Starter selection tables for various voltage ratings. ........................................................ 6
3.3.5.1 Starter selection for 230V, 400V, 480V, 600V ......................................................... 6
3.3.6 Ordering Information ....................................................................................................... 7
4. Recommended Wiring Scheme ............................................................................................... 8
4.1 Typical wiring diagram ................................................................................................................ 8
4.2 Power wiring scheme for “Inside-Delta” Connection .................................................................. 9
4.3 Wiring Notes ............................................................................................................................... 9
4.3.1 Short Circuit Protection ................................................................................................. 10
4.3.2 Transient Protection ...................................................................................................... 10
4.3.3 Control Supply (Terminals A1, A2) ................................................................................
10
4.3.4 S
tart/Stop (or
4.3.4momentary start) Input (terminal B1) .............................................. 10
4.3.5 Aux. Input (terminal C1) ................................................................................................ 11
4.3.6 Auxiliary output relay (terminals 13, 14) ........................................................................ 11
4.3.7 Fault Contact (terminals 23, 24) .................................................................................... 11
4.3.8 Options description ....................................................................................................... 11
4.3.8.1 Analogue I/O (option # 5) (terminals T1, T2, Gnd, Out (-), Out (+)) ...................... 11
4.3.8.2 RS-485 Communication (option # 3M) (terminals out(-),Out(+)) ........................... 12
4.3.9 “Inside-Delta” mode ....................................................................................................... 12
4.3.9.1 General information ................................................................................................ 12
4.3.9.2 Notes on “Inside Delta” connection ........................................................................ 13
5. Dimensions ............................................................................................................................. 14
6. Installation ............................................................................................................................... 18
6.1 Prior to Installation .................................................................................................................... 18
6.2 Mounting ................................................................................................................................... 18
6.3 Temperature range & heat dissipation ...................................................................................... 18
6.3.1 Calculating the enclosure size, for non-ventilated metallic enclosure ........................... 18
6.3.2 Additional Ventilation ..................................................................................................... 19
6.3.3 UL, cUL Installation Instructions .................................................................................... 19
7. Control Keypad ....................................................................................................................... 20
7.1 LCD Arrangement ..................................................................................................................... 20
7.2 Push-buttons .............................................................................................................................
20
7.3 S
tatus LEDs. ............................................................................................................................. 21
7.4 Reviewing and Modifying Parameters ...................................................................................... 21
7.5 Special Actions Performed in TEST/MAINTENANCE Mode ....................................................
21
7.5.1 R
un Self Test ................................................................................................................ 21
7.5.2 View Software Version .................................................................................................. 21
To Next Page
Loading...
Need help?
General
