DAW Control GuidE
5-12
AWS 900+ Owner’s Manual
Motion Control Panel
Transport Controls
Dedicated transport controls are provided for direct control over your DAW:
ONLINE* Puts the DAW on line for synchronisation
LOOP* Toggles Loop mode on/off (hold down CTRL for Loop Record mode)
Q PUNCH* Toggles Quickpunch recording status on/off for your DAW
PRE* Toggles the pre-roll function for your DAW. See next page for setting Pre roll time
POST* Toggles the post -roll function for your DAW. See next page for setting Post roll time
*The status of these functions is shown in the transport section of the TFT screen.
IN Captures the current DAW position as the Start edit time.
OUT Captures the urrent DAW position as the End edit time.
RTZ (Return-To-Zero) Returns the playback cursor to the Session start time
END (Go-To-End) Moves the playback cursor to the end of the Session
REWIND Holding down this button will rewind the DAW (increment depends upon Display mode)
FAST FORWARD Holding down this button will fast forward the DAW (increment depends upon Display
mode)
STOP Stops playback or recording
PLAY Depending on the Pro Tools settings c ommences playback from the current cursor
position or the last locate point, depending on DAW settings.
RECORD Engages DAW recording for currently armed tracks
Other useful transport modes
Half-speed Playback SHIFT + PLAY
Abort Current Record Pass SHIFT + STOP
Cycle through Record Modes (Normal, Quickpunch, TrackPunch, Loop) CTRL + RECORD
Cycle through Machine Control Masters (accessible via the transport window) CTRL + ONLINE
Link or Unlink the Edit and Timelines SHIFT + Back slash(/)
To Next Page
Loading...
Need help?
General
