Solid State Logic AWS 900+ User Manual

Removing the trim
If it is necessary to remove the trim panels – to adjoin existing furniture – then please refer to the following
information and the illustration shown on the facing page.
Note that it is not necessary to remove any of the audio modules to gain access to the trim fixing screws.
Front Buffer
The front buffer is secured by nine pan-head screws – five in the front beam and two in each end trim. These
are all visible from beneath the buffer.
End Trim
Each of the end trims is secured by four countersunk Posi-head screws through the profile (one is located in
the kneepanel area, two more are found either side of the main beam and the fourth is located on the bottom
corner of the outside profile), as well as two pan-head screws through the front buffer (visible from beneath the
buffer).
Top Trim
The top trim is clipped over the front of the meter panels and secured onto the back panels by four M3 screws.
AWS 900+ Owner’s Manual
3-5
Installation and Setup

Solid State Logic AWS 900+ Specifications

General

Brand	Solid State Logic
Model	AWS 900+
Category	DJ Equipment
Language	English