Solid State Logic SSL UF1 User Manual

Studio One Tutorial
91
SSL UF1 User Guide
PLUG-IN mapping and control explained
Press the PLUGIN key to go into 'Control Link' Mode. The 2-digit V-Pot assignment mode reads PL.
In Studio One, you customise which plug-in parameters are controlled on the V-Pots of UF1 for each and every
plug-in you want to control. When you press the PLUGIN key for the first time, no plug-in parameters will be
available because you need to configure whilst in 'Control Link' Mode. We'll walk through the process in the
Setting Up Plug-In Control section.
1. Open up a plug-in you want to configure to be controlled by UF1's V-Pots and click the cog near the top-right.
2. Click the small down arrow near the top-left and make sure 'Recently Touched' is ticked from the drop-down list.
Click the cog
Click the down arrow
Tick 'Recently Touched'

Solid State Logic SSL UF1 Specifications

General

Brand	Solid State Logic
Model	SSL UF1
Category	DJ Equipment
Language	English