S2/S2BW
Digital Color Doppler Ultrasound System
Chapter 14
System Maintenance
We recommend the user to perform the following maintenance operations:
• Clean the probes and probe holders daily to remove coupling gel, dust, and etc.
• Clean the system (keyboard, monitor, and etc.) regularly.
Attention!
• Switch the system off before cleaning.
• Damp cloth soaked in mild soap water is allowed.
• Protect the system, especially the electric parts, from drip water.
• Do not apply acetone/alchohol or use abrasives on the system or the transducer surfaces.
14.1 Guidance for Service
In case of any malfunctions, turn off the system and disconnect the power supply. Contact your SonoScape
representative for service. Mention the detailed phenomena of the malfunction to the service personnel to
help the identification of cause.
Warning!
There are no user replaceable parts inside the system. Any kind of do-it-yourself repairs invalidate
the warranty. Contact your representative for service instead.
14.2 Manufacturer Responsibility
The manufacturer assumes the responsibility with regard to safety, reliability and performance of this product
only under the following conditions,
•
all installation, hardware and software upgrades, modifications and repairs of this product are performed
or instructed by authorized personnel;
• operation, transport and storage of this product are under the required environmental conditions;
• the product is operated in accordance with this operator’s manual.
14.3 Contact Information
Any feedbacks or inquires concerning our product or service should be directed to the following address.
P/N: 4710.00149A01
14-1
To Next Page
Loading...
Need help?
General
