Sony alpha 9 III - Wireless Flash

ILCE-9M2
5-010-473-11 (1)
GB
142
C:\5010473111\5010473111ILCE9M2IN5\01GB-ILCE9M2IN5\030BAS.indd
DTP data saved: 2019/07/26 13:31
PDF file created: 2019/08/06 10:22
Note
• The FEL lock cannot be set when a flash is not attached.
• If a flash that does not support the FEL lock is attached, an error message is
displayed.
• When both AE and FEL lock are fixed, lights up.
Wireless Flash
There are two methods for wireless flash shooting: light-signal flash
shooting that uses the light of the flash attached to the camera as a signal
light, and radio-signal flash shooting that uses wireless communication. To
perform radio-signal flash shooting, use a compatible flash or the Wireless
Radio Commander (sold separately).
For details on how to set each method, refer to the instruction manual of
the flash or the Wireless Radio Commander.
1
MENU  (Camera Settings 1)  [Wireless Flash]  [On].
Off: Does not use the wireless flash function.
On: Uses the wireless flash function to make an external flash or flashes
emit light at a distance from the camera.
2
Remove the shoe cap from the camera, and then attach the
flash or the Wireless Radio Commander.
• When performing light-signal wireless flash shooting, set the
attached flash as the controller.
When performing radio-signal wireless flash shooting with a flash
attached to the camera, set the attached flash as the commander.
3
Set up an off-camera flash that is set to wireless mode, or that
is attached to the Wireless Radio Receiver (sold separately).
• You can perform a test flashing by assigning the [Wireless Test Flash]
function to a custom key using [
Custom Key], and then pressing
that key.