Before installing the front speakers
of
BDV-E500W on a wall, you need to disassemble the speakers.
You can install the upper part
of
a speaker on a wall.
Rear of the speaker
o
o
o
~
~~~~\::~
l l
o
o
()
0
Rear of the speaker
o
o
o
o
o
Screw
18
US
2 Remove the screw (pre-installed) at the rear
of
the speaker.
This screw is used when reassembling the speaker. Be sure not to lose the screw.
Caution
• Contact a screw shop
or
installer regarding the wall material or screws to be used.
• Use screws that are suitable for the wall material and strength. As a plaster board wall is especially fragile, attach
the screws securely to a beam and fasten them to the wall. Install the speakers on a vertical and flat wall where
reinforcement is applied.
• Sony is not responsible for accidents
or
damage caused by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
To
disassemble
the
speaker
(Front speakers
of
BDV-E500W only)
1 Disconnect the speaker cords from the speaker.
To Next Page
Loading...
