3-11
BRC-300/300P
BRU-300/300P
3-2. BRC-300/300P Camera Block Electrical Alignment
3. Date initialization of pages E, F, 1E, and 1F
m
. When reading or writing the data of page 1E or 1F,
select page: 0, address: 10, and set data: 01, then select
the page E or F. The page 1E or 1F can be chosen by this
data setting.
After reading or writing, reset the data of page: 0,
address: 10 to “00”.
. If “Date initialization of pages E, F, 1E, and 1F” is
performed, all data of the pages E, F, 1E, and 1F will be
initialized. (It is impossible to initialize a single page.)
. After initializing the data of pages E, F, 1E, and 1F,
perform the all adjustments in Sections 3-2-8 and 3-2-21
again.
Adjusting page Adjusting address
E 00 to FF
F 10 to FF
1E 00 to C3
1F 00 to FF
Initializing method
Order Page Address Data Procedure
1 0 01 01 Set the data.
2 0 10 00 Set the data.
3 6 01 Set the following data, and
press PAUSE button.
2D (NTSC)
2F (PAL)
4 6 03 01 Set the data, and press
PAUSE button.
5 6 02 Check that the data changes to
“01”.
To Next Page
Loading...
