Step 1 Preparing the power supply
Use tile batter T pack after charging it %1"your camcorder.
Your camcorder operates only with tile "InfBLITHIIdM" battery pack (M series).
(1) Open the DC IN jack covet" and connect the AC power adaptor supplied with
your camcorder to the DC IN jack with the plug's • mark fhciog up.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
(4) Set the POWER switch to OFF (CHG). The CHARGE lamp (orange) lights up.
Charging begins.
When the CHARGE lamp goes out, normal charge is completed. For full charge,
which allows you to use the battery longer than usual, leave the battery pack in place
fbr approximately one hour after the CHARGE lamp goes out.
¢1
CHARGElamp_
2
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your ean-leorder.
Notes
• Prevent metallic objects fi'om coming into contact with the metal parts of tbe DC plug
of the AC power adaptor. This may cause a short circuit, damaging the AC power
adaptor.
• Keep the battery pack chy.
• When the battery pack is not to be used fbr a long time, charge the battery pack once
fltlly and then use it tmtil it fltlly discharges again. Keep the battery pack in a cool
place.
11
To Next Page
