Focusing manually
To focus precisely
It is easier to focus on the subject if you adjust the zoom to shoot at the "W" (wide
angle) after fort/sing at the "T" (telephoto) position.
When you shoot close to the subject
Focus at tlle end of tlle "W" (wide angle) position.
_'_ changes as follows:
when recording a distant subject
--=when tile subject is too close to focus on
Focal distance information is displayed as _ 1.2 m for about 3 seconds on the LCD
screen or in the viewfinder in the following cases:
When switrhing the forus adjustment mode flora autoforus to manual
When tinning the focus ring
Focal distance information
This inf_ormation is aids focusing if it is not easy to focus on the subject, for example,
when recording in the dark. Use this information as a rough guide to get a sharp
fOCUS.
You cannot get correct inf_ormation ifyou have attached a conversion lens to your
Call-lcorder.
When focal distance is from more than 50m to _, focal distance infomation is
displayed as _ 50 m.
46
To Next Page
Loading...
