Sony DCR-PC110 - Searching a Recording by Date

Searching a recording by date - Date search
Note
Ifone day's recording is less than 2 minutes, your can-lcorder may not accurately find
tile point where the recording date changes.
In the _ mark
• Tile bar in the _ mark indicates tile present point on tile tape.
• Tile _ mark in the _ indicates the actual point you are trying to search.
If a tape has a blank portion between recorded portions
The date search f\mction may not work correctly.
Cassette memory
The tape cassette memory can hold 6 recording date data. If you search the date among
7 o1"nlore data, see "Searching fur the date vv-ithout using cassette memory" below.
m
(1) Set the POWER switch to VCR.
(2) Set CM SEARCH in _ to OFF in the menu settings (p. 84).
(3) Press SEARCH MODE on the Remote Commander repeatedly, until the DATE
SEARCH indicator appears.
The indicator changes as follows: 8'
DATE SEARCH ---+PHOTO SEARCH ---+ PHOTO SCAN _=
(4) Press _ on the Remote Commander to search for the previous date or press
on the Remote Commander to search for the next date. Your camcorder
automatically starts playback at the point where the date changes. Each time
you press _ or I_1, your camcorder searches for the previous or next date.
To stop searching
Press II.
53