-- Advanced Recording Operations --
Recordinga still image on a tape - Tape Photo recording
You can record an still image, for example, a photograph o1"drawing. This mode is
usefill when you want to print a image using a video printer (not supplied).
You can record about 510 images in tile SP mode and about 765 images in tile LP mode
on a 60 minute tape.
Besides the operation described here, your camcorder can record still images oil
"Memo W Stick"s (p. 102).
(1) In the standby mode, keep pressing PHOTO lightly tmtil a still image appears.
The CAPTURE indicator appears. Recording does not start yet.
To change the still image, release PHOTO, select a still image again, and then
press and hold PHOTO lightly.
(2) Press PHOTO deeper.
The still image on the LCD screen or in the viewfinder is recorded for about
7 seconds. The sound during those 7 seconds is also recorded.
The still image is displayed on the LCD screen or in the viewfinder until
recording is completed.
2
g
;o
0
5'
©
Notes
• During tape photo recording, you cannot change the inode o1"setting.
•When recording a still image, do not shake your camcorder. Tile image may fluctuate.
•You cannot use PHOTO dining following operations:
Fader
Digital effect
If you record a moving subject with tape photo recording function
When yon play back tile still image oil other equipnmnt, tile image may fluctuate.
To use the tape photo recording function using the Remote Commander
Press PHOTO oil tile Remote C_on-lmander. Your cameorder records an image oil tile
LCD screen or in the viewfinder immediately.
To usethe tape photo recordingfunction during normal CAMERArecording
You cannot cheek an image on the LCD screen or in tile viewfinder by pressing PHOTO
lightly. Press PHOTO deeper. The still image is then recorded for about 7 seconds, and
your camcorder returns to the standby mode.
To record clear and less fluctuated still images
_Ve recomnlend that yon record oil "Memory Stick"s.
29
To Next Page
