Playing back a tape
Press DISPLAY on your camcorder or the Remote Commander snpplied with your
camcorder. Tile indicators appeal on the LCD screen. To make tile indicators disappear,
press DISPLAY again.
DISPLAY
Using the data code function
Your eamcorder automatically records not only images on tile tape but also the
recording data (date/time or vmious settings when recorded) (Data code). Use tbe
Remote Commander for this operation.
PressDATA CODEon the Remote Commanderin the playback mode.
The display changes as follows:
date/time --,, various settings (SteadyShot, exposure, white balance, gain, shutter
speed, aperture value mode) --,, no indicator
Date/time
JOL 4 2OOO
_Z055_ AM
[a] SteadyShot off indicator
[b] Exposure mode indicator
[c] White balance indicator
[d] Gain indicator
[e] Shutter speed indicator
[f] Apertme value
Various settings
r [b]
/_.... _r- [c]
Not to display various settings
Set DATA CODE to DATE in the menu settings (p. 84).
Tim display changes as follows: date/tin-le *--* no indicator
Recordingdata
Recording data is your can-lcorder's in%rmation wben yon have recorded. In the
recording mode, the recording data will not be displayed.
When you usethe data code function, bars(...... ) appear if:
A blank portion of tbe tape is being played back.
The tape is tmreadable due to tape damage or noise.
The tape was recorded by a camcorder without the date and time set.
g
I
Data code
When you connect your eamcorder to the TV. tim data code appears on tbe TV screen.
25
To Next Page
